Nouvelle maj officielle de l'axe II:
New Axe-Fx II Firmware 5.04b released
Axe-Fx Firmware version 5.04b has been released on our web site.
Changed remote patch dump protocol so that presets are synchronized with Global blocks. This improves Axe-Edit performance.
Fixed Global Patches so that corruption does not occur if parameters were added in a firmware upgrade.
Improved power tube saturation modeling. This results in a smoother tone when the virtual power amp is driven hard. The beta team was pretty enthusiastic about this improvement.
Added Air Freq parameter to Cabinet block. This allows adjusting the cutoff frequency of the mixed signal.
A new version of Axe-Edit is expected shortly.
http://www.fractalaudio.com/support.php
Comme moi si vous avez rater des épisodes entre la mise à jour officielle 5.01 et 5.04b voici le contenu des autres maj.
J'imagine que ce n'est que les bêta testeurs qu'ils les ont eu:
5.03
Fixed GUI stall on certain combinations of effects in a preset.
Disabled MIDI Thru and Adapter Mode during firmware updates.
*******************************************************************************
5.02
Decreased damping on Delay block Input.
Added HF Resonance control back into Amp block. This control is similar to the previous control but only changes the slope of the resonance. The default value is consistent with the typical “semi-inductance” of a speaker voice-coil. Varying this value will change the high-frequency load presented to the virtual power tubes.
Added “CALI LEGGY” amp model based on a Carvin Legacy I.
La suite au prochain épisode de "Cliff et ses mises à jour"
